Victor CA-370 Heavy Duty Cutting Torch: Fitment Checklist (Tips, Regulators, Hoses)
A heavy duty cutting torch is only as good as the system behind it. Wrong tip series, wrong regulator setup, or a leaking hose will show up as poor preheat, unstable cuts, and repeat downtime. This guide is centered on the Victor 0387-0206 CA-370 (WH370FC) and is written to prevent wrong orders.
Key Takeaways
- •SKU 0387-0206 is a Victor CA-370 heavy duty cutting torch (WH370FC).
- •Tip fitment is the most common wrong-order point: confirm the correct Victor tip series and size for your thickness.
- •Regulator inlet (CGA) and hose end fittings must match your cylinders and torch setup. Do not force threads.
- •Use the Victor tip chart for your exact tip size and fuel gas to set oxygen/fuel pressures correctly.
Product Overview (What It Is / Who Uses It)
The Victor CA-370 is a heavy duty oxy-fuel cutting torch built for higher-duty cutting work where a lighter torch can feel underbuilt. Typical users include fabrication shops, maintenance teams, and field crews cutting structural steel and thicker plate.
If you are upgrading because your current torch is overheating, leaking, or struggling to maintain a stable preheat, the correct move is to verify the full system: torch, tips, regulators, and hose.
Specs & Compatibility Checklist
- Torch: Victor CA-370 heavy duty cutting torch
- SKU: 0387-0206
- Alternate identifier: WH370FC
- Cutting tip compatibility: Victor cutting tips (select the correct tip series and size for your torch and thickness).
- Fuel gas: oxygen + fuel (acetylene/propane/natural gas). Tip selection and regulator setup must match your fuel.
- Pressure ranges: set per Victor tip chart for your exact tip size and fuel gas.
Publishing fixed pressure numbers is a common way to create wrong setups. Use the Victor tip chart for your exact tip and fuel gas.
Typical Applications
- • Structural steel cutting in fab shops
- • Thick plate cutting (tip selection drives performance)
- • Maintenance cutting where portability and reliability matter
Maintenance & Care
- Leak-check every setup: use an approved leak-detection solution on all connections.
- Keep tip seats clean: dirt on seats causes leaks and unstable flames.
- Inspect hoses: replace cracked, burned, or oil-contaminated hose.
- Protect the torch: damaged seats become repeat leak points.
- Service when controls feel rough: stiff valves and creeping leaks are signs to rebuild/replace wear parts.
Comparison Block
- • Heavy duty torch platform for higher-duty cutting
- • Best when you cut thicker material or run longer cycles
- • Verify tip series + fuel gas setup before you order tips
- • Lighter-duty alternative for general cutting
- • Often chosen for intermittent use
- • Still requires correct tips, regulators, and hose fittings
- • Comparable heavy duty category
- • Tip compatibility differs by brand
- • Verify tips, mixers, and repair parts before ordering
Fitment note: torch families are not tip-interchangeable across brands. Confirm the exact tip series for your torch.
Accessories & Consumables
Related Guides
Safety Note (ANSI/AWS)
Oxy-fuel equipment is safety-critical. Follow ANSI/AWS guidance and the Victor manual for setup. Do not use oil/grease on oxygen service equipment. Leak-check every connection, use flashback arrestors/check valves as required, and keep cylinders secured. If you see damaged threads, regulator creep, or persistent leaks, stop and have the equipment inspected by a qualified technician.
Add to Cart or Confirm Fitment First
Add the Victor 0387-0206 CA-370 torch to your cart. Not sure on tips or regulator setup? Call with your fuel gas (acetylene/propane), typical thickness, and cylinder CGA so we can prevent a wrong order.